1
Earthquake Engineering (EE-UQ) / Running EE-UQ backend using Command Line or MATLAB
« on: March 31, 2021, 03:27:52 AM »
Good evening, all! Just wanted to ask for best practices if I would like to run EE-UQ within a MATLAB routine.
Based on previous posts, my understanding is that record selection must be done prior to running the backend (the PEER NGA record selection feature wouldn't be available), and the "Multiple PEER" option should be selected.
To run the full analysis, would I need to "loop" through each downloaded ground motion and run the EE-UQ workflow using a custom BIM.json file for each iteration?
I'm just brainstorming at this stage, so any input on (1) if my understanding on the implementation is correct and (2) the specific lines of code needed to run each analysis would be much appreciated.
Thank you!
Based on previous posts, my understanding is that record selection must be done prior to running the backend (the PEER NGA record selection feature wouldn't be available), and the "Multiple PEER" option should be selected.
To run the full analysis, would I need to "loop" through each downloaded ground motion and run the EE-UQ workflow using a custom BIM.json file for each iteration?
I'm just brainstorming at this stage, so any input on (1) if my understanding on the implementation is correct and (2) the specific lines of code needed to run each analysis would be much appreciated.
Thank you!