Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - mv_cutti

Pages: [1]
1
Site Response Analysis (s3hark) / Re: soil column model
« on: April 22, 2021, 12:47:34 PM »
Yes, is different the syntax but the command is the same.
In the first case I "set nonlinear 1" and then I write the command "updateMaterialStage -material materialtag -stage $nonlinear"
In the second case I directly used the comman "updateMaterialStage -material materialtag -stage 1"
Why did you say that they are different?


2
Site Response Analysis (s3hark) / Re: soil column model
« on: April 20, 2021, 11:34:39 PM »
Where they are different? I attached here the file testmodify.tcl in which I have changed the order of the comand but is the same as the test.tcl file that I have attached before

3
Site Response Analysis (s3hark) / Re: soil column model
« on: April 18, 2021, 07:06:09 PM »
I attached two .tcl files for sharing my work. They are the same model, have the same geometry, the same material, the same elemente, the same boundary conditions but they are written with two different syntax (if you open the .tcl files you see what I'm saying) and so I expected the same results but aren't. I don't understand where I'm wrong  :-[

4
Site Response Analysis (s3hark) / soil column model
« on: April 16, 2021, 07:46:05 PM »
Hi everybody,
I wanna ask you this question.
I tried to compare the two files that I had attached below.
These two files are the same model written in two different ways.
I don't understand why they give me different results in term of surface displacement.
Can someone help me???
  :-\

5
Site Response Analysis (s3hark) / Plot results / model
« on: December 15, 2020, 05:12:17 PM »
Hi everybody  :D,

I red the documentation but I did not found what I was searching for. So I ask you this two questions:
1) how can I plot the results in .xlsx format?
2) what kind of model S3hark create in Opensees? Do it use finite or infinite elements? Do it use dashpot or something else?

Thank you,

Marco

Pages: [1]