Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - cdup

Pages: [1]
1
Wind Engineering (WE-UQ) / turbulentInflow mesh constrain
« on: November 09, 2021, 01:36:23 PM »
First of all, thank you for this useful tool!!
I found your turbulentInflow tools very useful and I'm now trying to use them.

Iím using ANSA (BETA CAE Systems) mesh generator (instead of blockMesh). Iíve reproduced Jay's examples provided in the folder tutorials/inhomogeneousTurbulence/ DFDFSEM /channel395 with a different mesh size. My first goal is to make them run for 10 sec (single proc).

Therefore, Iíve created a fully structured hexa mesh and I ran it ten sec without any issue.
My second test is an unstructured hexa mesh which doesnít run.
Code: [Select]
Turbulent DFDFSEM patch: inlet seeded 401 eddies with total volume 34.9364
mass flow correction coefficient: 1.00045
#0  Foam::error::printStack(Foam::Ostream&) at ??:?
#1  Foam::sigFpe::sigHandler(int) at ??:?
Ö

Then Iíve reduced the size of the meshes and they are now running fine.

Hence, here is my question, is there, according to your knowledge, any constrain for the mesh (size and type) to use your tools ?

By the way, I'm expecting to use it for wind load calculations.

If required, Iíll be pleased to send you my testcases. (fine mesh are quite heavy for the forum, 50Mo). I've attached the log files of the unstructured Hexa mesh.

Thank you in advance for your feed back.

Best regards,

Cedric

Pages: [1]