Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Messages - ParsaTInflow

Pages: [1]
Wind Engineering (WE-UQ) / Integral length scale in DFMethod
« on: February 23, 2021, 02:05:30 PM »

I hope that this message finds you very well.
I have a question regarding the integral length scale calculation in Digital filter method.
I run a test case (sort of similar to the homogeneous turbulence available in the tutorial), and plot the mean value, rms of velocity fluctuation on the center-line of the box.
I calculate the cross correlation function for a specified point on the inlet. The value of the correlation is equal to one when Ruu(0) and is equal to zero when Ruu(inf) (Which make sense).
Now my concern is: In the majority of experimental work, the value of the integral length scale is equal to the integration of the correlation function when its value is equal to zero. What I mean is: The correlation function should be integrated from Ruu(0) until Ruu(..) = 0.
In the simulation, I set the value of longitudinal integral length scale to 1 (mm), and by calculating the length scale with the above methodology, I end of getting a value of equal to 2 (mm).
I tested this for a couple of more models and the results are the same!

Please advice me on this issue.


Wind Engineering (WE-UQ) / Re: Turbulent Inlet Flow for OF-8
« on: February 08, 2021, 07:39:37 AM »
Dear Ajay,

Thank you so much for your prompt reply.


Wind Engineering (WE-UQ) / Turbulent Inlet Flow for OF-8
« on: February 07, 2021, 05:25:34 PM »
Dear Peter,

I hope that this message finds you very well.
I intend to use the turbulent inflow library for generating turbulent flow. However, I would like to know if this library will be available for OF-version 8 or not!?

My best regards,

Pages: [1]